Epson AcuLaser CX37DN Series User Manual page 234

This message...
PAPER SIZE ERROR
RESET PAPER (xxx)
PC CONNECTION FAILED
REMOVE ORIGINAL
IN ADF
REPLACE TONER
CHANGE x TONER
RESULTS ARE OVER xxx
SERVER MEMORY FULL
SMTP Server
THE PARTY IS FULL
Toner Low x
Trans. Belt Life
Trans. Roll. Life
TRAYx OPEN
CLOSE TRAYx
USB Dev. Not support
USB Hub Not support
Epson AcuLaser CX37 Series
means...
Paper of the selected size is not
loaded in a paper tray.
While data was being sent in Scan
mode, the connection to the
computer was interrupted.
The document is loaded in the
ADF while a function is set that
requires scanning from the
original glass.
The indicated toner cartridge has
become empty.
The LDAP search results exceed
the maximum specified with
MAX. SEARCH RESULTS in the
LDAP SETTING menu.
The memory of the SMTP server
has become full.
The maximum number of 236
destinations for the scan data has
been reached.
The indicated toner cartridge is
nearly empty.
The time to replace the transfer
belt unit has been reached.
The time to replace the transfer
roller has been reached.
The indicated paper tray is open.
A USB device incompatible with
this machine is connected.
A USB hub is connected to this
machine.
Printer/Copier/Scanner User's Guide
Do this...
Load paper of the selected size into a
paper tray.
Check the connection with the
computer and the scanner driver
status, and then try sending the data
again.
Place the document on the original
glass.
Replace the indicated toner
cartridge.
Change the maximum setting, or
change the search conditions (for
example, increase the length of the
keyword), and then try performing
the LDAP search again.
Free up some space on the disk, for
example, by contacting your server
administrator.
Send the data, and then try scanning
again. Otherwise, delete unnecessary
destinations before adding the
desired ones.
Prepare the indicated toner
cartridge.
Contact your vendor or authorized
service provider.
Contact your vendor or authorized
service provider.
Close the indicated paper tray.
Disconnect the USB device from this
machine.
This machine is not compatible with a
USB hub. When connecting USB
cables to this machine, do not use a
USB hub.
Troubleshooting 234