Got Controller Setting - Mitsubishi Electric MELSERVO-J5 Series Sample Screen Manual

GOT controller setting

(1) Controller setting
■Settings for each channel
Item
CH
Manufacturer
Controller
CH1
Type
I/F
Manufacturer
Controller
CH2
Type
I/F
CH3
CH4
*1: If the temporary settings are used in the default configuration of the sample, a communication timeout will
occur in CH1. Avoid this by setting one of the following.
(1) Change the IP address on the PLC side.
Change the IP address of Connected Ethernet Controller Setting so that it has the same network system
as CH2 in [Common] - [Controller Setting].
(2) Use an Ethernet communication unit (GT25-J71E71-100).
Set [Extended Port] in [GOT Ethernet Setting] - [GOT IP Address Setting].
(For GT25-W, set [Port 2].)
■CH2 detail setting
GOT Ne t No.
GOT Station
GOT Communication Port No.
Retry (Times)
Startup Time (Sec)
Timeout Time (Sec)
Delay Time (ms)
Servo axis switching GD device first No. (16
points)
■CH2 connected Ethernet controller setting
Host Net No.
1
1 *
1
2
1
3
1
4
* Set the number of connected servo amplifiers in accordance with your system configuration.
Set value
MITSUBISHI ELECTRIC
MELSEC iQ-R, RnMT/NC/RT, CR800-D
Ethernet: Multi
MITSUBISHI ELECTRIC
MELSERVO-J5(W)-*G(-RJ), -JET-*G
Ethernet: Multi
None
None
Item
Station Unit Type
1 MR-J5(D)-G/
MR-JET-G
2 MR-J5(D)-G/
MR-JET-G
3 MR-J5(D)-G/
MR-JET-G
4 MR-J5(D)-G/
MR-JET-G
110/128
These settings are temporary
because it is assumed that
CH1 is used.*1
For communication with servo
amplifiers.
These channels are used to
temporarily save virtual
devices when changing the
controller type of CH2.
Set value
1 (fixed) (Default value)
18 (Default value)
5035 (Default value)
3 (Default value)
3 (Default value)
3 (Default value)
0 (Default value)
65400
IP Address Port No.
192.168.3.1
192.168.3.2
192.168.3.3
192.168.3.4
Remarks
Remarks
-
-
-
-
-
-
-
-
Communication
5010
UDP
5010
UDP
5010
UDP
5010
UDP
BCN-P5999-1471-3c