Sample Project Data Setting - Mitsubishi Electric MELSERVO-J5 Series Sample Screen Manual

Sample project data setting

Change the settings of the sample project data by following the procedure below.
(1) Change the controller type of CH2.
⇒ "8.6.2.1 Changing the controller type and virtual devices in a batch"
(2) Change the recipe setting.
⇒ "8.6.2.2 Changing the recipe setting"
(3) Modify the items on the Axis Selection screen (B-16000).
⇒ "8.6.2.3 Editing the Axis Selection screen (B-16000)"
8.6.2.1 Changing the controller type and virtual devices in a batch
Changing the controller type of CH2 changes the communication driver, which makes the servo amplifier virtual
devices invalid.
To avoid this, it is necessary to save the virtual devices before changing the controller type.
The virtual devices can be changed in a batch by any of the following methods.
⇒ "■Editing data with GT Designer3"
⇒ "■Editing data with a CSV file exported from GT Designer3"
The following shows an example of the procedure for saving virtual devices.
■Editing data with GT Designer3
(1) Set [Manufacturer], [Controller Type], and [I/F] for unused channel.
Manufacturer
Controller Type
I/F
*Change the value of [GOT Communication Port No.] from the default to avoid overlap with that of CH2.
Item Set value
MITSUBISHI ELECTRIC
MELSERVO-J5(W)-*G(-RJ), -JET-*G
Ethernet: Multi
113/128
BCN-P5999-1471-3c