Jumper Settings - Supermicro X13SWA-TF User Manual

Super X13SWA-TF User's Manual

2.9 Jumper Settings

How Jumpers Work
To modify the operation of the motherboard, jumpers can be
used to choose between optional settings. Jumpers create shorts
between two pins to change the function of the connector. Pin 1
is identified with a square solder pad on the printed circuit board.
See the diagram below for an example of jumping pins 1 and 2.
Refer to the motherboard layout page for jumper locations.
Note 1: On two-pin jumpers, "Closed" means the jumper is
on and "Open" means the jumper is off the pins.
Note 2: Unplug the power cord from all power supplies before adjusting jumper settings.
CMOS Clear
JBT1 is used to clear CMOS, which will also clear any passwords. Instead of pins, the JBT1
jumper consists of contact pads to prevent accidentally clearing the contents of CMOS.
To Clear CMOS
1. First power down the system and unplug the power cord(s).
2. Remove the cover of the chassis to access the motherboard and remove the battery
from the motherboard.
3. To clear CMOS, short the CMOS pads with a metal object such as a small screwdriver
for at least four seconds. Then remove the screwdriver (or shorting device).
4. Replace the cover, reconnect the power cord(s), and power on the system.
Note: Clearing CMOS will also clear all passwords.
HD AUDIO
JUIDB1
LED4
5
(UID-LED)
JPAC1
JSPDIF_OUT AUDIO FP
BMC
BMC LED
JPW2
M.2-C04
(PCIe 5.0 X4)
LED7 (M.2-C04 LED)
LED8
1
JBT1
BIOS LICENSE BIOS LICENSE
X13SWA-TF
DIMME2
REV:1.01
DIMME1
DESIGNED IN USA
DIMMF2
DIMMF1
MAC CODE
PCH PCH
DIMMG2
USB0/1
DIMMG1
DIMMH2
DIMMH1
U.2-2 U.2-1
JSD1 SATA0 SATA2 SATA5 SATA7
SATA1 SATA3 SATA4 SATA6
USB11
FAN1 FAN2
(USB3.2 Gen.2x2)
LAN2 LAN1
USB10
USB6/7 USB8/9 COM1
USB2/3
(USB3.2 Gen 2X2) (USB3.2 Gen 2x1) (USB3.2 Gen 2x1) VGA
JPL2
JPUSB1
LAN
LAN CTRL
CTRL
JPL1
DIMMD1
DIMMD2
DIMMC1
DIMMC2
DIMMB1
DIMMB2
DIMMA1
DIMMA2
SP1
JD1
JPI2C1
(SPEAKER 1-4)
(PWR I2C)
LED1
JPW1
JSTBY1 FAN3 FAN4
(Power LED)
JF1
1. JBT1
66
3 2 1
Connector
Pins
Jumper
3 2 1
Setting