Supermicro X13SWA-TF User Manual page 120

Super X13SWA-TF User's Manual
3. Select Reset. When asked to remove the RAID structure on the disk, select Yes to
reset the disk.
Note: When resetting a disk, all data on the disk will be deleted as well.
Intel(R) I210 Gigabit Network Connection - (MAC address)
Note: The Ethernet controller and MAC addresses shown above are based on you
system features.
Firmware Image Properties
The following information is displayed:
•
Option ROM Version
•
Unique NVM/EEPROM ID
•
NVM Version
•
Family Firmware Version
•
EFI Version
NIC Configuration
Legacy Boot Protocol
Selects the non-UEFI boot protocol. Options are None, PXE, iSCSI Primary, and iSCSI
Secondary.
Link Speed
Use this feature to set the connection speed of a LAN port specified. The options are Auto
Negotiated, 10 Mbps Half, 10 Mbps Full, 100 Mbps Half, and 100 Mbps Full.
Wake On LAN
Set this feature to support system wake-up via the selected LAN device. If this feature is
set to Enabled, the LAN port selected will be enabled when the system is powered on. The
options are Disabled and Enabled.
Legacy Virtual LAN ID
Specifies the VLAN ID used for PXE VLAN mode. The valid VLAN ID range is from 0
to 4049. PXE VLAN is disabled if the VLAN ID is set to 0. Note that this settings is only
applicable when the system ROM boots in Legacy BIOS mode.
120