Supermicro X13SWA-TF User Manual page 37

DIMM Installation
1. Insert the desired number of
DIMMs into the memory slots
based on the recommended
DIMM population tables in
the previous section. Locate
DIMM memory slots on the
motherboard as shown on the
left.
2. Align the DIMM module key with the receptive point on
the single-latch DIMM slot.
3. Push the release tab outwards to unlock the slot.
4. Align the notch on the end of the module against the
receptive point on the end of the slot.
5. Press both ends of the module straight down into the slot
until the module snaps into place.
6. Push the release tab to the lock position to secure the
module into the slot.
DIMM Removal
Press the release tab on one end of the DIMM module to
unlock it. Once the DIMM module is loosened, remove it from
the memory slot.
Warning! Please do not use excessive force when pressing the release tabs on the ends of the
DIMM socket to avoid causing any damage to the DIMM module or the DIMM socket. Please
handle DIMM modules with care. Carefully follow all the instructions given on Page 1 of this
chapter to avoid ESD-related damages done to your memory modules or components.
X13SWA-TF
REV:1.01
DESIGNED IN USA
DIMM Slots for Intel Xeon
W-3400 series CPU (112L)
37
Chapter 2: Installation
X13SWA-TF
REV:1.01
DESIGNED IN USA
DIMM Slots for Intel Xeon
W-2400 series CPU (64L)
Receptive Point
Notch
Release Tab
Press both notches
straight down into
the memory slot.