Supermicro X13SWA-TF User Manual page 67

LAN Port Enable/Disable
JPL1 and JPL2 allow you to enable the onboard LAN ports (LAN1 and LAN2). The default
setting is pins 1-2 to enable the connections. Refer to the table below for jumper settings.
ME Manufacturing Mode
JPME2 is used for ME Firmware Recovery mode, which will limit system resource for essential
function use only without putting restrictions on power use. In the single operation mode,
online upgrade will be available via Recovery mode. Refer to the table below for jumper
settings.
JUIDB1
LED4
(UID-LED)
JPAC1
JSPDIF_OUT
AUDIO FP
BMC
BMC LED
M.2-C04
(PCIe 5.0 X4)
LED7 (M.2-C04 LED)
LED8
JBT1
BIOS LICENSE BIOS LICENSE
X13SWA-TF
DIMME2
REV:1.01
DIMME1
DESIGNED IN USA
DIMMF2
DIMMF1
MAC CODE
PCH PCH
DIMMG2
USB0/1
DIMMG1
DIMMH2
DIMMH1
U.2-2 U.2-1
JSD1 SATA0 SATA2 SATA5 SATA7
SATA1 SATA3 SATA4 SATA6
USB11
(USB3.2 Gen.2x2)
3
LAN Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enable
Pins 2-3 Disable
ME Recovery
Jumper Settings
Jumper Setting Definition
Pins 1-2 Normal (Default)
Pins 2-3 ME Manufacturing Mode
LAN2 LAN1
HD AUDIO
USB10 USB6/7 USB8/9
COM1
(USB3.2 Gen 2X2) USB2/3
(USB3.2 Gen 2x1) (USB3.2 Gen 2x1) VGA
5
2
JPL2
JPUSB1
JPW2
LAN
LAN CTRL
CTRL
1
JPL1
DIMMD1
DIMMD2
DIMMC1
DIMMC2
DIMMB1
DIMMB2
DIMMA1
DIMMA2
SP1
JD1
JPI2C1
(SPEAKER 1-4)
(PWR I2C)
LED1
JPW1
FAN1 FAN2 JSTBY1 FAN3 FAN4
(Power LED)
JF1
67
Chapter 2: Installation
1. LAN1 Enable/Disable (JPL1)
2. LAN2 Enable/Disable (JPL2)
3. ME Manufacturing Mode (JPME2)