Supermicro X13SWA-TF User Manual page 130

Super X13SWA-TF User's Manual
Subnet Mask (Available when "Configuration Address Source" is set to Static)
This feature displays the sub-network that this computer belongs to. The value of each three-
digit number separated by dots should not exceed 255.
Gateway IP Address (Available when "Configuration Address Source" is set to
Static)
This feature displays the Gateway IP address for this computer. This should be in decimal
and in dotted quad form (i.e., 172.29.0.1).
VLAN (Available when "Update BMC LAN Configuration" is set to Yes)
This feature displays the status of virtual LAN (VLAN) support. The options are Disable and
Enable.
VLAN ID (Available when "VLAN" is set to Enable)
Use this feature to create a new VLAN ID by using an existing VLAN or creating a new VLAN
ID. Enter a valid value between 1 – 4094. The default setting is 1.
*****************************
Configure IPv6 Support
******************************
IPv6 Address Status
This feature displays the status of the IPv6 address.
IPv6 Support
Use this feature to enable IPv6 support. The options are Enabled and Disabled.
Configuration Address Source (Available when "IPv6 Support" is set to Enabled)
Use this feature to select the source of the IPv6 connection. If Static Configuration is selected,
you will need to know the IP address of IPv6 connection and enter it to the system manually
in the field. If the other two options are selected, the BIOS will search for a DHCP server in
the network that is attached to and request the next available IP address for this computer.
The options are Static Configuration, DHCPv6 Stateless, and DHCPv6 Stateful.
Station IPv6 Address ("Static", "DHCPv6 Stateless", or "DHCPv6 Stateful",
depending on the option you selected for "Configuration Address Source" above)
This feature displays the station IPv6 address. Press <Enter> to change the setting.
Prefix Length (Available when "Configuration Address Source" is set to Static
Configuration)
This feature displays the prefix length. Press <Enter> to change the setting.
130