Supermicro X13SWA-TF User Manual page 69

Watchdog
Watchdog (JWD1) is a system monitor that can reboot the system when a software application
hangs. Close pins 1-2 to reset the system if an application hangs. Close pins 2-3 to generate
a non-maskable interrupt (NMI) signal for the application that hangs. Refer to the table below
for jumper settings. For this function to work properly, please also enable the Watchdog
setting in the BIOS.
USB8/9 Standby Power
JPUSB1 allows you to enable or disable the USB8/9 power in S5 standby mode. The default
is on pins 1-2 to enable USB8/9 power in S5 standby mode. Refer to the table below for
jumper settings.
JUIDB1
LED4
(UID-LED)
JPAC1
JSPDIF_OUT
AUDIO FP
BMC
BMC LED
M.2-C04
(PCIe 5.0 X4)
LED7 (M.2-C04 LED)
LED8
JBT1
BIOS LICENSE BIOS LICENSE
X13SWA-TF
DIMME2
REV:1.01
DIMME1
DESIGNED IN USA
DIMMF2
DIMMF1
MAC CODE
PCH PCH
USB0/1 DIMMG2
DIMMG1
DIMMH2
DIMMH1
U.2-2 U.2-1
JSD1 SATA0 SATA2 SATA5 SATA7
SATA1 SATA3 SATA4 SATA6
USB11
(USB3.2 Gen.2x2)
Watchdog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
USB8/9 Standy Power Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disable
LAN2 LAN1
HD AUDIO
USB10 USB6/7 USB8/9
COM1
(USB3.2 Gen 2X2) USB2/3
(USB3.2 Gen 2x1) (USB3.2 Gen 2x1) VGA
5
2
JPL2
JPW2 JPUSB1
LAN
LAN CTRL
CTRL
JPL1
DIMMD1
DIMMD2
DIMMC1
DIMMC2
DIMMB1
DIMMB2
DIMMA1
DIMMA2
1
SP1
JD1
JPI2C1
(SPEAKER 1-4)
(PWR I2C)
LED1
JPW1
FAN1 FAN2 JSTBY1 FAN3 FAN4
(Power LED)
JF1
69
Chapter 2: Installation
1. Watchdog (JWD1)
2. USB8/9 Standby Power (JPUSB1)