Supermicro X13SWA-TF User Manual page 104

Super X13SWA-TF User's Manual
Support Aggressive Link Power Management (Available when "SATA Configuration"
is set to Enabled)
When this feature is set to Enabled, the SATA AHCI controller manages the power use of the
SATA link. The controller will put the link in a low power mode during an extended period of
I/O inactivity, and will return the link to an active state when I/O activity resumes. The options
are Disabled and Enabled.
SATA SGPIO Enable (Available when "SATA Configuration" is set to Enabled)
Use this feature to change the serial GPIO mode for SATA controller. The options are Disabled
and Enabled.
SATA Port 0 – SATA Port 7 (Available when "SATA Configuration" is set to Enabled)
Note: The SATA port naming may vary based on the related configuration.
Hot Plug
Select Enabled to support Hot-plugging for the device installed on a selected SATA port to
allow you to replace the device installed in the slot without shutting down the system. The
options are Disabled and Enabled.
Spin Up Device
Select Enabled for Staggered Spin Up support to allow the SATA devices specified by the
user to spin up one at a time at boot up in an effort to prevent all hard drive disks from
spinning up at the same time, causing a power surge. The options are Disabled and
Enabled.
SATA Device Type
Use this feature to specify if the device installed on the SATA port specified by the user
should be connected to a solid state drive or a hard disk drive. The options are Hard Disk
Drive and Solid State Drive.
Trusted Computing (Available when a TPM device is installed

and detected by the BIOS)
When a Trusted-Platform Module (TPM) device is detected by your system, the following
information is displayed:
•
TPM 2.0 Device Found
•
Firmware Version:
•
Vendor:
104