Honda BF15D Manual page 85

BF15DmBF20D
4) Apply thin coat of grease to the outside of the liner to hold
them in the impeller housing, install the pump liner and
impeller as an assembly by aligning the tabs of the liner
with the groove of the impeller housing.
1
[ l ] GROOVE
[2]
IMPELLER LINER
I
[3] BOSS
[4] IMPELLER HOUSING
5) Apply marine grease to a new O-ring and install it to the
impeller housing.
6) Apply thin coat of grease to the key setting groove of the
vertical shaft and set the key.
7)
Install the impeller housing assembly by aligning the key
groove of the impeller with the key on the vertical shaft by
turning the vertical shaft clockwise taking care not to
come off the key from the vertical shaft.
[ l ] VERTICAL SHAFT
\
1
[2] IMPELLER
H 0 US IN G
[31
O-RING
/
KEY
8) Install the 6 x 50 mm washer bolts and tighten the bolts to
the specified torque.
TORQUE: 11 N*m (1.1 kgf m, 8 Ibf
ft)
9) Apply marin grease to th inside of the water tub- seal
ring and installit to the impeller housing. Install the water
pump housing grommet.
10)lnstall the following:
-
gear case assembly (P. 4-1 0 and 11)
-
propeller shaft holder (P. 4-8).
-
propeller (P. 4-2).
[ l ] 6 x 5 0 m m
WASHER BOLT (4)
--I
[ l ] PUMP HOUSING
1
GROMMET
SEAL
4-14