BF15D-BF20D
1) Apply grease to the shift shaft;
-
link pivot holes.
-
detente spring sliding area.
-
set plate sliding area.
2) Connect the shift shaft to the shift rod A then set it in the
place.
3) Tiller handle type;
Apply grease to the link rod, and connect the link rod to
the shift shaft. Install the 5 mm washer and a new 2 mm
cotter pin, spread the end of the cotter pin as shown.
Remote control type;
Apply grease to the link rod, and connect the link rod to
the shift shaft. Install the 7 mm washer and a new 2 mm
cotter pin, spread the end of the cotter pin as shown.
[3]
2 mm
COTTER PIN
~ 2 1 5
mm PLAIN
\
I
[4] LINK ROD
[3]
2
mm
COTTER PIN
[217 mm PLAIN
\
(0
\
WASHER
13-7