Honda BF15D Manual page 263

BF15D-BF20D
'lip engaged and
button pushed.
b. REPLACEMENT
1) Remove the 4 x 10 mrn self-tapping screw and wire clip.
2) Remove the 16 mrn lock nut and remove the starter
3) Install a new starter switch and tighten the 16 rnrn lock
switch from the starter switch housing.
nut to the specified torque.
TORQUE: 1.5 Narn (0.1 5 kgfam, 1.1 Ibf
aft)
mm self-tapping screw.
4) Set the wire clip in the place and secure it with the 4 x 10
There should be continuity.
5. EMERGENCY STOP SWITCH
a. INSPECTION
The emergency stop switch test can be performed with the
Check for continuity between the terminals according to the
table below.
switch installed on the tiller handle.
I
Clip engaged.
I
There should be no continuity.
I
~ ~~
I
Clip disengaged.
I
There should be continuity.
I
c--
I
b. REPLACEMENT
1) Remove the 16 mm lock nut and remove the emergency
2)
Install a new emergency stop switch and tighten the 16
stop switch. Replace if necessary.
mm lock nut to the specified torque.
TORQUE: 1.5 Narn (0.1 5 kgf am, 1.1 Ibf
e f t )
I31
4 x l O m m
121
STARTER SWITCH
SELF-TAPPING
A
1 1
1
EMERGENCY
STOP SWITCH
[31
TILLER
HANDLE
LOCK NUT
I
15-1 2