Honda BF15D Manual page 81

BF15D-BF20D
INSTAL LATl ON
Install the two 6 x 10 mm dowel pins on the gear case.
Apply marine grease to the following position:
-
spline of the vertical shaft.
-
inside of the water tube seal.
Install the gear case assembly by aligning the vertical
shaft spline with the crankshaft, and water tube with the
water tube seal.
Loosely install the 6 mm flange bolts or 6 mm self-locking
nuts.
Tighten the 6 mm flange bolts or 6 mm self-locking nuts
in a crisscross patter in 2-3 steps to the specified torque.
TORQUE: 12 N*m (1.2 kgfam, 9 Ibf*ft)
4 1 0