Honda BF15D Manual page 271

BF15DmBF20D
1)
Apply grease to the armature shaft, bearing and seal lip
of the front bracket, and sliding surface of the overrun-
ning clutch.
2) Install the front bracket onto the armature.
3) Install the overrunning clutch, washer, return spring and
pinion stopper.
4) Hold the armature upright and push down the pinion stop-
per using an offset wrench and install the stopper ring.
5) Make sure that the seal ring is in good condition, replace
if necessary. Install the seal ring onto the yoke.
Set the seal ring onto the stepped section of the yoke
properly taking care not to pinch with the yoke and
front bracket.
6) Make sure that there is no obstruction on the magnets.
Install the yoke noting the installation direction as shown
and align the index mark on the yoke with the index mark
on the front bracket.
[ I 1
OVER-RUNNING
CLUTCH
/
141
'51
P I
14 mm LOCK RING
PINION
--
STOPPER
FRONT [2] SEAL RING
STEPPED
SECTION
[4] YOKE
[5] Viewed from front bracket side
16-8