Honda BF15D Manual page 347

b. DISASSEMBLY
/NOTICE/
Do not disassemble the gear pump assembly. If it is
faulty, replace it as an assembly.
Do not use a shop towel, cloth, gloves, etc.
Do not reuse the drained automatic transmission fluid
(ATF).
Do not hold at the outer tube when holding the power tilt
assembly in a vise during operation.
Clean the removed parts in fresh automatic transmission
fluid (ATF), and blow each port of the parts with com-
pressed air. Set the parts neatly in a suitable container
with care not to contaminate them with dust and dirt.
Do not reuse the O-rings.
Remove each valve and sleeve with care not to damage
the sliding surface of the parts.
POWER TILT MOTOR
1) Connect the power tilt motor 2P connector and operate
the power tilt motor assembly until the piston rod extends
fully.
2) Loosen the manual valve fully.
3)
Remove the oil hole cap bolt and drain the ATF in the oil
tank through the bolt hole.
4) Remove the O-ring from the oil hole cap bolt and discard
it. Replace the O-ring with a new one on reassembly.
Do not drain the ATF by pushing in the piston rod.
5) Open the wire band clip and free the motor wire.
6) Remove the two socket bolts and washers, and remove
7) Drain the ATF from the valve body.
8)
Remove the two O-rings from the power tilt motor assem-
bly and discard them. Replace the O-rings with new ones
when reassembly.
the oil tank and power tilt motor assembly.
9) Remove the drive joint from the gear pump assembly.
131 CLIP BRACKET [4]SOCKET BOLT (2)
t21
WIRE BAND CLIP
:11
\
VALVE BODY
1
Donot reuse.
1
12-1 8