Honda BF15D Manual page 219

11)Drive the 3
x
25 mm spring pin using a commercially
available 3 mm pin driver until it comes clear of the upper
side of the tilt lever bracket.
12)Drive the 3 x 22 mm spring pin according to the above
procedure until it comes clear of upper side of the release
rod bracket.
13)Pull the spring pins out of the bracket using a vise pliers
and discard the spring pins. Replace the spring pins with
new ones when reassembly.
14)Remove the tilt lever, then remove the release rod,
15)Check the tilt lever bushing A for wear or damage.
release rod bracket tilt lever bracket.
Replace if necessary.
I
111 3 mm PIN DRIVER
(commercially available)
I
f l i T LEVER
SPRING PIN
SPRING PIN
[ l ] TILT LEVER 121
RELEASE ROD
\
BRACKET
131
TILT LEVER
BUSHING A (2)
TILT LEVER
151
RELEASE ROD
151
RELEASE ROD
12-1
3