Honda BF15D Manual page 373

BF15DoBF20D
i. INSTALLATION
Apply marine grease to upper cylinder bushing.
Set the power tilt assembly to the swivel case as shown
and install the upper cylinder pin and secure the 15 mm
external circlip.
Apply grease to the lower cylinder bushings and lower
cylinder collar, and install them on the power tilt assem-
bly.
Install the distance collar on the lower cylinder collar and
set the lower mount of the power tilt assembly between
the stern bracket.
Install the 8 x 203 mm hex. bolt, 8 mm washer and 8 mm
self-locking nut.
Pass the motor wire through the left stern bracket and set
the motor wire bushing by aligning the boss of the bush-
ing with groove on the left stern bracket as shown.
1 1
1
UPPER CYLINDER PIN
- -
[15] LEFT
STERN
BRACKET
/
41 MOTOR WIRE BUSHING
15 mm EXTERNAL
[4] 8 x 2 0 3 m m
HEX. BOLT
[5] ADJUSTING
ROD
[13] 8 mm SELF-LOCKING NUT
'
1121 8 mm WASHER
[ I 11 POWER TILT ASSEMBLY
[lo] DISTANCE COLLAR
[9] LOWER CYLINDER BUSHING (2)
.
161
LOWER CYLINDER
COLLAR
/
[8] 6 x 8 mm SCREW
171 GROUND WIRE
12-44