Honda BF15D Manual page 275

3) Route the starter magnetic switch wire and connect the
connectors, and set them to the connector bracket A.
See page 3-31 (Tiller handle type) or P3-33 (Remote
control type).
[ I ] 6 mm SELF-LOCKING NUT
I
4) Connect the starter cable to the starter magnetic switch
and adjust the terminal direction so that the starter cable
contacts to the clamp bracket on the starter magnetic
switch body as shown.
TORQUE: 5.5 N*m (0.55 kgf em, 4.0 Ibfoft)
6) Secure the battery cable, charge wire and control box
wire harness (Remote control type only) with the cable
band on the starter magnetic switch.
[2] STARTER
CABLE
5) Tighten the self-locking nut to the specified torque.
[3] WIRE BAND
7) Install the removed parts in the reverse order of removal:
-
flywheel (P. 9-1 1).
-
recoil starter (P. 7-9).
-
left engine under cover (P. 5-3).
-
engine cover (P. 5-1).
r3i WIREBAND
Secure battery cable and control box wire
harness (Remote control type) with the cable
band on the starter magnetic switch.
131-1 ~31-2
Tiller handle type
Remote control type
PI-3
CONTROL
BOX WIRE
HARNESS
s
PI-4
STARTER CABLE
c
[ l ] 6 mm SELF-LOCKING NUT
1
5.5 N * m (0.55 kgf*m, 4.0 Ibfoft)
1
/
/
[4] CONNECTOR
BRACKET A
16-12