18)Connect the SE thermal valve wire connectors (Type with
19) Set the connectors and wires to the holders of the starter
electric starter).
case
6.
Refer to page 2-36 for connector location.
20)Connect the wire terminal to the oil pressure switch.
2l)lnstall the shift link rod to the shift shaft and install the 6
mm plain washer to the shift link rod and secure it with a
new 2 mm cotter pin.
Replace the 2 mm cotter pin with a new one, when
removed.
[l] CONNECTORS
AND WIRES
/
[3] HOLDERS
[21 SE THERMAL
VALVE WIRE
'
[l]' OIL PRESSURE
SWITCH
[l] COTTER PIN
w
[4] PIVOT BOLT
[3] SHIFT LINK ROD
8-1 1