Honda BF15D Manual page 365

BF15DoBF20D
I
11)Loosen the manual valve by turning it 3 turns or more.
12)lnstall the drive joint in the position of the gear pump
assembly as shown.
13)Fill the gear pump chamber with the fresh ATF up to the
upper edge of the chamber. If the ATF in the valve body
contains air bubbles, remove the air bubbles using an oil
bottle or equivalent tool.
Do not pour the ATF into the valve body gear pump
chamber quickly. Pour the fluid slowly.
Trapped air in the system causes faulty operation.
Remove the air bubbles in the fluid securely.
14)Apply the ATF to a new O-ring, and install it on the power
tilt motor assembly.
15) Install the power tilt motor assembly on the valve body so
that the power tilt motor wire is at the outer tube side and
align the motor shaft with the groove of the drive joint as
shown.
1 1
1
DRIVE JOINT
121
Pour the ATF up to the top edge.
1 ,
DRIVE JOINT
12-36