Honda BF15D Manual page 278

BF15DmBF20D
[ l ] WHITE WIRE
I NSTAL LATl ON
Install the oil case grommet to the starter cable and align
the inside of the grommet with the white tape on the
starter cable, and install them onto the oil case.
Secure the starter cable with the wire band clip and install
the starter cable bracket by aligning the cutout with the
boss on the oil case and tighten the 6 x 14 mm flange
bolt securely.
Route the starter cable.
Tighten the ground terminal to the cylinder block using
the
6
x 12 mm flange bolt.
Connect the starter cable to the starter magnetic switch
and adjust the terminal direction so that the starter cable
contacts to the clamp bracket on the starter magnetic
switch body as shown.
Tighten the self-locking nut t the specified torque.
TORQUE: 5.5 N*m (0.55 kgf m, 4.0 Ibf ft)
Secure the starter cable and control box wire harness
(Remote control type only) with the cable band on the
starter magnetic switch.
[7] OIL CASE
GROMMET CABLES
[3] STARTER CABLE
[5] BOSS
BAND CLIP
[2] 6 mm SELF-LOCKING NUT
1 STARTER
[3] GROUND
TERMINAL
16-15