Honda BF15D Manual page 390

c. INSTALLATION
1 )
Install the relay bracket with the 6 x 12 mm flange bolts.
2)
Install the power tilt relay to the mount rubber and install
3) Adjust the relay ground terminal direction and tighten the
them to the relay bracket.
6 x 12 mm flange bolt securely.
4) Route the power tilt relay wires and connect the connec-
5) Install the connector holder to the starter case B with the
6) Clamp the wires with the wire clips.
7) Secure the wire with the wire band.
8) Install the removed parts in the reverse order of removal.
tors.
mounting rubbers.
11
1
GROUND
TERMINAL
121
RELAY
BRACKET
I
x 14 (2)
\
[41
1
POWER TILT RELAY
[3] MOUNT RUBBER
[11
CONNECTOR
HOLDER
PI
WIRE CLIP
(2)