Reset Led (Led2); Usb Monitor Led (Zled3); User Leds (Led5-12, Led13-20) - Analog Devices ADSP-BF561 EZ-KIT Lite Manual

Reset LED (LED2)

When is lit, it indicates that the master reset of all major ICs is
LED2
active.

USB Monitor LED (ZLED3)

The USB monitor LED (
been initialized successfully and you can connect to the processor using a
VisualDSP++ EZ-KIT Lite session. This takes approximately 15 seconds.
If the LED does not light, try cycling power on the board and/or reinstall-
ing the USB driver.
When VisualDSP++ is actively communicating with the EZ-KIT
Lite target board, the LED can flicker, indicating communications
handshake.
User LEDs (LED5–12, LED13–20)
Sixteen LEDs connect to the processor's programmable flags. Eight LEDs
labeled through
LED5
through (equivalent to
PF47
through are controlled by programmable flags
LED20
(equivalent to
PPI1
and Push Buttons" on page
Table 2-12. User LEDs
LED Reference Designator Flag Port Name
LED5
LED6
LED7
LED8
ADSP-BF561 EZ-KIT Lite Evaluation System Manual
www.BDTIC.com/ADI
ADSP-BF561 EZ-KIT Lite Hardware Reference
) indicates that USB communication has
ZLED3
are controlled by programmable flags
LED12
_
PPI0 D15–8
_ ). To learn how to use the LEDs, refer to
D15 8
–
1-10.
PB40
PB41
PB42
PB43
). Eight LEDs labeled
PF32
LED Reference Designator Flag Port Name
LED13
LED14
LED15
LED16
PF40
LED13
through
PF39
"LEDs
PB32
PB33
PB34
PB35
2-17