Atlas Copco TPS Control User Manual page 42

User guide
Parameter name
Counted from
Define new code
Parameter name
Start position
Start counting from
Code
Job number
Service
Parameter name
User language
System information
Print out
Test functions
Reset parameter +
jobs
Reset jobs only
Reset system
Licence keys
Firmware update
Print-Out
Parameter name
Print parameters
Print jobs
Print all
42
Description
Id2 position to be counted from; either the head or the
tail of the barcode string
Description
Sets start position from where identification of the bar-
code should start.
Determines whether counting should start from begin-
ning or end of a barcode.
Specifies the characters in the barcode that, if found,
trigger a job to start.
Sets the job to start when the specified character code
is found in a barcode
Description
Selects the language used in the operating dialogue.
Possible options are English, German and French.
Gives information regarding Device ID, software ver-
sion and version number of the I/O modules and the
enabled options
Opens the submenu containing the printing functions
Opens the submenu containing the test functions
Resets all setup parameters to the factory settings and
deletes all jobs.
Deletes all jobs, but keeps the parameter settings.
Restarts the TPS Control system (according to the
power-on cycle)
Activates optional functions (in a separate submenu).
Activation codes can be ordered from Atlas Copco us-
ing the unit device ID
Prepares the unit for a firmware update through the
serial interface.
Description
Prints a plain text list of all setup parameters on the
serial interface
Prints a plain text list of all jobs on the serial interface
Prints all parameters and all jobs on the serial inter-
face
© Atlas Copco Industrial Technique AB - 9836 5819 01
EN TPS Control
Range/Values
head, tail
Default: head
Range/Values
1-255
Default: 1
head, tail
Default: head
A-Z, a-z, 0-9
1-63
Default: 1
Range/Values
English
Deutsch
Francais
Default: English
Range/Values