Table of Contents
Advertisement
Position the Access Point before Installation
Table 8: Mounting bracket usage (continued)
Mounting bracket and
part number
WS-MBO-POLE01
bracket
WS-MBV-VMM vehicle
bracket (#32216)
Note
All mounting brackets are sold separately.
Important
The AP460i/e access points use different mounting accessories than the AP460C,
AP460S6C, and AP460S12C series access points.
Position the Access Point before Installation
When you install the access point, the vent must be on the side closest to the ground, and not above
the plastic cover. You must provide a 3.0 in. (76.2 mm) drip loop on all cables. For more information, see
Form a Drip Loop Connection for Cables
Note
The sensor and BLE antennas come with a dust cap on them. Do not remove the dust cap
until you are ready to install the antennas.
Related Topics
Ground Connection
Form a Drip Loop Connection for Cables
16
ExtremeWireless™ AP460i/e Access Points
Wall install
No
Yes
on page 46.
on page 17
on page 46
Pole install
Yes. The POLE01 bracket
can only be used with
the MBO-ART02
articulating mounting
bracket
No
Install the Access Point
Notes
If the pole diameter is
>= 1.0 in. (25.4 mm), use
a small cable clamp. If
the pole diameter is
between 5.0 in. - 7.0 in.
(127.0 mm - 178.0 mm),
use a large cable clamp.
For any other pole
diameter, provide your
own stainless steel cable
clamp. The band must
be 0.5 in. (12.7 mm)
wide.
The VMM vehicle
bracket has four parts:
• Flat plate with
thumbscrews
• Stiffener plate 1
• Stiffener plate 2
• Vehicle attach
assembly plate
Advertisement
Table of Contents
