Snmp Information; Traps - Digi CM 8 User Manual

Alerts and notifications
3 Fill in the required fields. SMTP with authentication and POP before SMTP require usernames
and passwords.
4 Click Save & apply.

SNMP information

Applications such as NMS (Network Management System) or an SNMP browser can exchange
information with the Digi CM unit and control actions to the unit. The protocol functions defined for
SNMP includes GET, SET, GET-Next, GET-Bulk, and TRAP. Below are the definitions of the protocol
functions found in SNMP. Authentication, power on, and link up traps are supported.
.
Protocol
GET
SET
GET-Next
GET-Bulk
TRAP

Traps

There are additional traps that can be set at the port level. The following table shows where the trap
is under Serial port > Configuration on the web interface, trap name, configure options, and the
trap functions. The MIBs for login traps can be found at http://ftp.digi.com/support/utilities/digicm/
Trap Location Trap Name
Port access menu Port login trap
Alert configuration Port login trap
Digi CM User Guide
Function
Queries a device for more information
Makes changes to a device's state
After an initial GET query, goes to the next value
Retrieves tables of information and security functions
Notifies a system administrator of a significant event
Function
Notify about any login action to the port access menu
(succeed and fail)
Notify about login to this specific port (succeed and fail)
(only available if host mode is set to "Console server")

SNMP information

58