Digi Connect SP User Manual page 87

•
Serial modem signals. (display serial).
•
General status of the sockets resource (display sockets).
•
Active TCP sessions and active TCP listeners (display tcp).
•
Current UDP listeners (display udp).
•
Point-to-Point Protocol (PPP) information.
•
Uptime information (display uptime).
info commands
The info commands displays statistical information about a device over time. The statistics displayed are those
gathered since the tables containing the statistics were last cleared. Statistics include:
•
Device statistics. info device displays such details as product, MAC address, boot, POST, and firmware versions,
memory usage, utilization, and uptime.
•
Ethernet statistics. info ethernet displays statistics regarding the Ethernet interface, including the number of
bytes and packets sent and received, the number of incoming and outgoing bytes that were discarded or that
contained errors, the number of Rx overruns, the number of times the transmitter has been reset, and the number
of incoming bytes when the protocol was unknown.
•
ICMP statistics. info icmp displays the number of messages, bad messages, and destination unreachable
messages received.
•
Serial statistics. info serial displays the number of bytes received and transmitted, signal changes, FIFO and
buffer overruns, framing and parity errors, and breaks detected.
•
TCP statistics. info tcp displays the number of segments received or sent, the number of active and passive
opens, the number of bad segments received, the number of failed connection attempts, the number of segments
retransmitted, and the number of established connections that have been reset.
•
UDP statistics. info udp displays the number of datagrams received or sent, bad datagrams received, and the
number of received datagrams that were discarded because the specified port was invalid.
•
Wireless statistics. info wlan displays detailed statistics for wireless devices that may aid in troubleshooting
network communication problems with a wireless network.
set alarm
set alarm displays alarm settings, including conditions that trigger alarms, and how alarms are sent, either as an
email message, an SNMP trap, or both. You can configure the alarms as needed.
set gpio
set gpio displays current GPIO pin settings. You can reconfigure the pin settings as needed.
set buffer and display buffers
set buffer configures buffering parameters on a port and displays the current port buffer configuration. display
buffers displays the contents of a port buffer, or transfers the port-buffer contents to a server running Trivial File
Transfer Protocol (TFTP).
set snmp
set snmp configures SNMP, including SNMP traps, such as authentication failure, cold start, link up, and login traps,
and displays current SNMP settings.
Digi Connect Family and ConnectPort TS Family User Guide 87