Digi Connect SP User Manual page 74

3. Launch the Discovery application on the laptop and proceed with the configuration.
Command line access
Note To set the DIP switches on the Digi Connect Wi-SP (or SP), ALWAYS disconnect the power supply before
resetting the switches. See the following procedure for more details.
1. Disconnect the power supply.
2. Set the Digi Connect Wi-SP DIP switches in the On or up position. The figure shows DIP Switch settings for
Command Line access for both the Digi Connect Wi-SP and the Digi Connect SP.
3. Connect the Digi Connect Wi-SP to a computer with a serial cable.
4. Access a terminal emulation program such as HyperTerm.
Choose Start > Accessories > Communication > Hyperterm and type a name for the connection.
5. Select COM1 and click OK.
6. Set the port settings to 9600, 8, None, 1, None (default settings) click Apply then OK.
7. Type the default user name: root
and the default password: dbps
8. Use the set wlan command to configure wireless network settings. This command is described in the Digi Connect
Family Command Reference, available for download from the Digi Support site and, for products that ship with a
Software and Documentation CD, on the CD.
9. After configuring the Digi Connect Wi-SP parameters to function within your network, disconnect the power
supply and the serial cable from the Digi Connect Wi-SP.
Digi Connect Family and ConnectPort TS Family User Guide
ON
1 2 3 4
74