Multimedia Interfaces; Lvds/Mipi-Dsi Display - Digi ConnectCore 8X SBC Pro Hardware Reference Manual

Interfaces
Note The USB bus connected to the XBee socket is also connected to the expansion header. See
Host for detailed information.

Multimedia interfaces

LVDS/MIPI-DSI display

The two MIPI-DSI/LVDS combo PHYs supported by the ConnectCore 8X module are available over two
different display connectors (J14 and J16) on the top side of the board:
MIPI_DSI0 bus is connected to J14.
n
MIPI_DSI1 bus is connected to J16.
n
These are 20-pin, 1.25 mm pitch connectors, which provide access to the following capabilities:
Up to four differential data pairs.
n
One differential clock pair.
n
Interrupt signal with 10K pull-up resistor for touch screen.
n
Control of the backlight contrast.
n
I2C.
n
3.3V power supply.
n
5V power supply.
n
Both the connectors exhibit the same pinout:
Pin Signal name
1 3V3_EXT
2 MIPI_DSI0/1_DATA0_N
3 MIPI_DSI0/1_DATA0_P
4 GND
5 MIPI_DSI0/1_DATA1_N
6 MIPI_DSI0/1_DATA1_P
7 GND
8 MIPI_DSI0/1_DATA2_N
9 MIPI_DSI0/1_DATA2_P
10 GND
11 MIPI_DSI0/1_CLK_N
12 MIPI_DSI0/1_CLK_P
13 GND
ConnectCore® 8X SBC Pro Hardware Reference Manual
Description
3.3V power supply line.
Transmission pair 0 data line (-).
Transmission pair 0 data line (+).
Transmission pair 1 data line (-).
Transmission pair 1 data line (+).
Transmission pair 2 data line (-).
Transmission pair 2 data line (+).
Transmission pair clock line (-).
Transmission pair clock line (+).
Multimedia interfaces
USB
21