Snmp Information - Digi CM 32 User Manual

SNMP Information

•
•
•
To configure SMTP alerts on the Digi CM, do the following:
1. Access the web interface.
2. Under the Network Configuration heading choose SMTP configuration.
3. Fill in the required fields. SMTP with authentication and POP before SMTP
4. Choose Save to flash and Apply changes.
SNMP Information
Applications such as NMS (Network Management System) or an SNMP
browser can exchange information with the Digi CM and control actions to the
The Digi CM
unit. The protocol functions defined for SNMP includes GET, SET, GET-Next,
supports SNMP
authentication
GET-Bulk, and TRAP. Below are the definitions of the protocol functions found
traps.
in SNMP. Authentication traps are supported by the Digi CM.
Configuring SNMP
To configure the Digi CM for SNMP do the following:
1. Access the Digi CM web interface.
2. Under the Network Configuration heading choose SNMP configuration.
3. Fill in information for the MIB-II system objects section and choose Yes
40
Device mail address: Specifies the sender's email address for the log and
alarm delivery
SMTP mode: The type of SMTP server you want to use
Username and password: Required for POP before SMTP and SMTP with
authentication servers
require usernames and passwords.
Protocol
GET queries a device for more information
SET makes changes to a device's state
GET-Next after an initial GET query, goes to the next value
GET-Bulk retrieves tables of information and security functions
TRAP notifies a system administrator of a significant event
under EnableAuthenTrap.
• sysContact: Identity of the contact person managing the MIB-II system.
Function
Chapter 6