Digi One SP Quick Start Manual

Quick Start Guide
Digi One® SP
1 Verify your components
Verify that you have all included equipment. If any item is missing or damaged, contact your supplier.
Included equipment
Digi One SP
Note A loose label sticker that includes the unique device password is included in the box. Retain this label sticker with your hardware records. This default password will be
needed if the device is factory reset.
2 Connect the hardware
1. Connect the serial cable.
2. Connect the power supply.
3. Connect the Ethernet cable.
Note Once power is connected, the lights blink while the system boots up and the red power light blinks until the IP address is assigned.
3 Download the required documentation and software
Documentation and software for this product is online.
1. Navigate to www.digi.com/support/digionesp.
2. Click the Product Support tab, then click the Digi One Family and PortServer TS Family User Guide link to open the user guide for this product.
© 2020 Digi International Inc.
Digi, Digi International, and the Digi logo are trademarks or registered trademarks in the United States and other countries worldwide. All other trademarks mentioned in this document are the
property of their respective owners.
Welcome to your Digi product
Get started: This guide helps you with initial product setup. Need more? Find additional supporting material for
this product at www.digi.com/support/digionesp. Or connect to the online documentation by scanning
this code:
Digi Technical Support: Digi offers multiple support plans to help you get the most out of your product. For
information on Technical Support plans and pricing, contact us at 877.912.3444 or visit www.digi.com/support.
Documentation feedback: To provide feedback on this documentation, send your comments to
techcomm@digi.com.
Diagnostic loopback plug
(some models may have a DC power cord or have
Power supply
no power supply)
Power supply adapters
(non U.S. models only)