Regulatory And Other Information - Digi Inside Out Watchport Installation Manual

Monitoring appliances
Table of Contents

Advertisement

Regulatory and Other Information

© 2005 Inside Out Networks, Inc. Digi, Digi
International,
the
Digi
Connectware logo, Inside Out Networks, the
Inside Out Networks logo and USB Over IP,
Watchport, Edgeport and Hubport are either
trademarks or registered trademarks of Digi
International, Inc. in the United States and/or
other countries. All other trademarks are the
property of their respective holders.
Information in this documentation is subject
to change without notice and does not
represent a commitment on the part of
Inside Out Networks Inc.
Inside Out Networks provides this document
"as is," without warranty of any kind, either
expressed or implied, including, but not
limited to, the particular purpose. Inside Out
Networks may make improvements and/or
changes to this documentation or to the
product(s) and/or program(s) described in
this documentation at any time.
Inside
Out
Networks
responsibility
of
any
inaccuracies, or typographical errors that
may appear in this documentation, nor
liability for any damages arising out of its
use. Changes are made periodically to the
information herein; these changes may be
incorporated
in
new
publication.
For U.S. Government use:
Any
provision
of
this
associated computer programs to the U.S.
Government is with "Restricted Rights." Use,
duplication, or disclosure by the government
is subject to the restrictions set forth in,
subparagraph (c) (1) (ii) of the Rights in
Technical Data and Computer Software
clause of DFARS 52.277-7013.
For non-U.S. Government use:
These programs are supplied under a
license. They may be used, disclosed,
and/or copied only as supplied under such
license agreement. Any copy must contain
the above copyright notice and restricted
rights
notice.
Use,
disclosure
of
the
programs
prohibited unless otherwise provided for in
the license agreement.
Watchport Installation Guide (90000406 Rev. D) – Page 19
logo,
the
Digi
assumes
no
errors,
technical
editions
of
the
document
and
copying,
and/or
is
strictly
Federal
Communications
(FCC) Regulatory Information (USA only)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable
protection
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and
used
in
accordance
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television
reception,
determined by turning the equipment off and
on, the user is encouraged to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and the receiver.
• Connect the equipment into an outlet
that is on a circuit different from the
receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Warning: The connection of a non-shielded
interface cable to this equipment will
invalidate the FCC Certification for this
device.
FCC Regulation - Part 15
Declaration of Conformity (DoC)
This device complies with the requirements
of the Code of Federal Regulations listed
below:
FCC Title 47 CFR, Part 15 Class B for a
digital device.
Operation is subject to the following two
conditions:
This
device
may
not
interference, and
Commission
against
harmful
with
the
which
can
be
cause
harmful

Advertisement

Table of Contents
loading

Table of Contents