Administration From The Command-Line Interface - Digi Connect SP User Manual

2. Click Restore.

Administration from the command-line interface

You can perform administrative tasks for Digi devices from the command line. Here are several device-administration
tasks and the commands used to perform them. See the Digi Connect Family Command Reference for more complete
command descriptions. For descriptions of these commands, see the Digi Connect Family Command Reference.
Administrative task
Backup/restore a configuration from a
TFTP server on the network
Update firmware
Reset configuration to factory defaults
Display system information and statistics info
Reboot the device
Enable/disable network services
Digi Connect Family and ConnectPort TS Family User Guide
Command
backup
boot
Telnet to the Digi device's command line interface
using a telnet application or hyperterm.
If security is enabled for the Digi device, a login prompt
appears. The default user name is root and the default
password is dbps. If these defaults do not work,
contact the system administrator who set up the
device.
Issue the command:
#> boot load=tftp-server-ip:filename
where tftp-server-ip is the IP address of the TFTP
server that contains the firmware, and filename is the
name of the file to upload.
revert
or
boot action=factory
boot
set service
94