When Used In Stand Alone Operation - NEC PG-6200 User Manual

When used in stand alone operation.

Pin No. SHORT/OPEN
14 SHORT
OPEN
5 SHORT
OPEN
10 SHORT
OPEN
4 SHORT
OPEN
The term "SHORT" means to connect with pin 15
• When in the external control mode, the POWER, INPUT and PICTURE MUTE buttons on the remote control will not function.
NOTE: Pin 13 is the external remote signal terminal. The projector can be controlled by the same format signal as the supplied
remote control from the external controller regardless of setting Pin 14.
NOTE: When turning the power on using the external control, short Pin 5 about three seconds after supplying the AC power to the
projector; when turning the power off using the external control, power off the AC supply to the projector about three seconds after
opening Pin 5. These procedures are to protect your projector and the connected equipment.
FUNCTION
External control mode ON
External control mode OFF
POWER ON
POWER OFF
PICTURE MUTE ON
PICTURE MUTE OFF
VIDEO
RGB
15
EXAMPLES OF CONNECTIONS