NEC PG-6200 User Manual page 94

5 Use the CURSOR
or
"DEFAULT" and press ENTER.
• Selecting "LAST" completes setting. Go on to step 7.
• Selecting "DEFAULT" displays the "Default input" screen. Go
on to step 6.
Items to select
• LAST ....... Sets the projector to default to the previous last
active input each time the projector is turned on.
Note: An input must be active for a minimum of 10
minutes before it is recognized as the last active
signal.
• DEFAULT . Displays the same source input every time the
projector is started up.
6 Use the CURSOR
or
the ENTER button.
When used in stand alone operation:
The default input screen will be displayed.
Use the CURSOR or
"S-VIDEO" and press ENTER.
When used with a single Switcher:
The "MASTER" slot menu will be displayed.
Use the CURSOR or
number "1" through "10(0)" and then press ENTER.
When used with two or more Switchers:
The "MASTER" and "SLAVE" slot number menu will be
displayed.
Use the CURSOR or
first and then select the slave slot number "1" through "10(0)".
Press ENTER.
button to select either "LAST" or
button to select an input and then press
button to select "VIDEO", "RGB", or
button to select the desired slot
button to select the master slot number
M A S T E R
S L O T – 0 1
S L O T – 0 2
S L O T – 0 3
S L O T – 0 4
S L O T – 0 5
S L O T – 0 6
S L O T – 0 7
S L O T – 0 8
S L O T – 0 9
S L O T – 1 0
73
D E F A U L T I N P U T S E L E C T
L A S T
D E F A U L T
VIDEO
RGB
S-VIDEO
M A S T E R
S L O T – 0 1
S L O T – 0 2
S L O T – 0 3
S L O T – 0 4
S L O T – 0 5
S L O T – 0 6
S L O T – 0 7
S L O T – 0 8
S L O T – 0 9
S L O T – 1 0
S L A V E
S L O T – 0 1
S L O T – 0 2
S L O T – 0 3
S L O T – 0 4
S L O T – 0 5
S L O T – 0 6
S L O T – 0 7
S L O T – 0 8
S L O T – 0 9
S L O T – 1 0
SETTING