NEC PG-6200 User Manual page 65

4 Press the R, G, and B buttons to display only the Green pattern.
• You can turn on or off each CRT beam (R, G or B) separately.
• To access the CONVERGENCE screen (see page 42), press and
hold down the CTL button then press the R or B button.
5 Use the CURSOR buttons to adjust the alignment of the pro-
jected pattern.
• The CURSOR or
horizontal level.
The CURSOR or
level.
For "PHASE" adjustment, follow the instructions below.
PHASE Adjustment
1) Use the CURSOR
horizontal line).
Adjust the pattern so the sharp turns at the left and right edges
in the diagonal lines are equal.
2) Use the CURSOR
(for vertical line).
Align the vertical center line of the point cursor with the
screen center.
(When the point Convergence Board is installed:)
3) Align the point peak with the screen center using CTL and
CURSOR buttons.
NOTE: Since the projector has been pre-adjusted for the optimal
phase adjustments at the factory, further adjustment should not
be required in normal operation.
6 To end this adjustment, press the END button.
• Whenever the END button is pressed, the menus will sequence
in this order:
"ALIGNMENT" menu
• If the "RETURN USER MODE?" menu appears, use the
CURSOR or button to select either "YES" or "NO" and
then press ENTER. This will exit the ADJUST mode.
Items to select
• YES ......... When you try to enter the ADJUST mode again,
you will need to re-enter your passcode.
• NO ........... When you try to enter the ADJUST mode again,
you will not need to re-enter your passcode.
button increases or decreases the
button increases or decreases the vertical
or button to adjust the tilt phase (for
or button to adjust the cursor phase
"ADJUST" menu Source screen
TILT PHASE
PHASE
CURSOR PHASE
POINT PHASE
Point Convergence board.)
37
ADJUSTMENT
- TILT CURSOR -
T 10%
C 90%
PHASE
- TILT CURSOR -
T
C
(When installing the
PHASE
- TILT CURSOR -
T
C
RETURN USER MODE?
Y E S N O
10%
32%
10%
32%