When Used In Stand Alone Operation - NEC MultiSync XT5000 User Manual

When used in stand alone operation.

Pin No.
14
5
10
11pin
4,8,12,11
OPEN
OPEN
OPEN
OPEN
OPEN
OPEN
OPEN
OPEN
SHORT
SHORT
* When the combinations other than specified in the above table are selected, the input will be forcefully switched to RGB 1.
* The term "SHORT" means to connect with pin 15
* When in the external control mode, the POWER, INPUT and PICTURE MUTE buttons on the remote control will not function.
NOTE: Pin 13 is the external remote signal terminal. The projector can be controlled by the same format signal as the supplied remote control
from the external controller regardless of setting on Pin 14.
NOTE: When turning off the power to the projector using the external control, do not disconnect the plug from the power outlet. These
procedures are to protect your projector and the connected equipment.
SHORT/OPEN
SHORT
OPEN
SHORT
OPEN
SHORT
OPEN
12pin 8pin
OPEN OPEN
OPEN OPEN
OPEN SHORT
OPEN SHORT
SHORT OPEN
SHORT OPEN
SHORT SHORT
SHORT SHORT
OPEN OPEN
OPEN SHORT
External control mode ON
External control mode OFF
POWER ON
POWER OFF
PICTURE MUTE ON
PICTURE MUTE OFF
4pin
RGB 1 (INPUT 1)
OPEN
SHORT VIDEO 1 (INPUT 5)
OPEN S-VIDEO 1 (INPUT 7)
COMPONENT (INPUT 4)
SHORT
OPEN SDI
SHORT
RGB 2 (INPUT 2)
OPEN VIDEO 2 (INPUT 6)
SHORT
S-VIDEO 2 (INPUT 8)
OPEN
RGB (DIGITAL) (INPUT 9)
OPEN RGB 3 (INPUT 3)
E – 27
FUNCTION