NEC PG-6200 User Manual page 71

5 Hold down the CTL button then select the CRT you wish to
adjust with the R and B buttons.
NOTE: Always be aware of what color the on-screen CRT
display is showing (R, B). If that color's test pattern is turned
off, any adjustment to that color displays the "THIS COLOR IS
NOT APPLICABLE" message.
• To access the ALIGNMENT screen (see page 36), press and
hold down the CTL button then press the G button.
6 Align the Red or the Blue pattern with the Green pattern using
the CURSOR buttons.
• The CURSOR button
The CURSOR button
The following are the description of the KEYSTONE, PIN-
CUSHION, and LINEAR-BALANCE adjustments.
KEYSTONE, PINCUSHION, and LINEAR-BALANCE
Adjustments
• Press and hold the CTL button then press any one of the
CURSOR buttons to select the position to be adjusted.
CTL + .... U (Up)
CTL + .... D (Down)
CTL + .... R (Right)
CTL + .... L (Left)
• Use the CURSOR buttons to correct the error.
7 Repeat steps 3 to 6 for the other CRTs if necessary.
• Pressing the END button will bring you to the "CONVER-
GENCE" menu.
8 To exit, press END to display the "STORE?" menu.
• Whenever the END button is pressed, the menus will sequence
in this order:
"CONVERGENCE" menu
screen
• If the "RETURN USER MODE?" menu appears, use the
CURSOR or button to select either "YES" or "NO" and
then press ENTER. This will exit the ADJUST mode.
Items to select
• YES ......... When you try to enter the ADJUST mode again,
you will need to re-enter your passcode.
• NO ........... When you try to enter the ADJUST mode again,
you will not need to re-enter your passcode.
NOTE: Adjusting the dynamic convergence may cause the static
convergence settings to change. If this happens, adjust the
static convergence again.
or increases or decreases H level.
or increases or decreases V level.
"ADJUST" menu
During alignment or convergence adjustment, if the projector
acknowledges that your adjustment is overcorrected, the
"ABNORMAL CORRECTION DATA" message appears. The data
is cancelled at that moment. If this happens, reduce the total
amount of the current adjustment data.
Source
43
C O N V E R G E N C E
- T I L T , S K E W -
C R T - R -
H
V
C O N V E R G E N C E
- T I L T , S K E W -
C R T - R -
H
V A B N O R M A L C O R R E C T I O N D A T A
C O N V E R G E N C E
- K E Y - S T O N E -
C R T - R -
U
RETURN USER MODE?
Y E S N O
ADJUSTMENT
1 0 %
9 0 %
1 0 %
1 0 %