NEC PG-6200 User Manual page 70

ADJUSTMENT
Dynamic Convergence Adjustment
Corrects the horizontal and vertical error for each color and align the
red and blue to the green.
NOTE:
• The dynamic convergence adjustment should be performed for
each CRT (R and B) separately.
• Select the CROSS-COARSE test pattern using the TEST button on
the full function remote control.
Proceed as follows:
1 Press the ADJUST button to display the "ADJUST" menu.
• The projector may ask you to enter your passcode.
See page 52 for the explanation of the PASSCODE.
2 Use the CURSOR
or
GENCE" line. Press ENTER to display the "CONVERGENCE"
menu. You can also select the "CONVERGENCE" menu directly
by pressing the INPUT "4" button.
• "6/R, G, B GAIN" is not included in stand alone adjust menu.
3 Use the CURSOR
or
then press ENTER. You can also select directly the dynamic
convergence item by pressing an INPUT button.
• The selected adjustment will be displayed.
See pages 44 and 45 for the explanation of the selected adjust-
ment.
NOTE: You can also select adjustments directly using buttons
on the full function remote control. If you are in the ALIGN-
MENT mode (see page 36), press and hold down the CTL
button then press the R or B button. This will bring you to the
CONVERGENCE adjustment screen. To select "LINEAR-BAL"
convergence, press and hold down the CTL button then press
the LINEAR button.
4 Press the R or B button to display the CRT beam to be aligned
with the Green pattern.
• You can turn on or off each CRT beam (R and B) separately.
button to highlight the "4/CONVER-
button to select the preferred item and
– A D J U S T –
1 / S I G N A L E N T R Y
2 / F O C U S
3 / A L I G N M E N T
4 / C O N V E R G E N C E
5 / W H I T E B A L
6 / R , G , B G A I N
7 / H O U R M E T E R
8 / P A S S C O D E
9 / O P T I O N
– C O N V E R G E N C E –
1 / T I L T , S K E W
2 / B O W
3 / A M P L I T U D E
4 / L I N E A R I T Y
5 / K E Y - S T O N E
6 / P I N - C U S H I O N
7 / L I N E A R - B A L
8 / P O I N T
42