NEC PG-6200 User Manual page 89

SETTING
S-Video Mode Selection
This function is used to select the S-video signal detection mode.
This allows identifying of the S-video signals with different aspect
ratio: squeeze or full mode(16 : 9) and letter box (4 : 3) signals.
To set, proceed as follows:
1 Press the ADJUST button to display the "ADJUST" menu.
• The projector may ask you to enter your passcode.
See page 52 for the explanation of the PASSCODE.
2 Use the CURSOR
or
line. Press ENTER to display the "OPTION" menu. You can also
select the "OPTION" menu directly by pressing the INPUT "9"
button.
• The eighth item is "8/OPTION" in stand alone adjust menu.
3 Use the CURSOR
or
MODE" line. Press ENTER to display the "SETTING MODE"
menu. You can also select the "SETTING MODE" menu directly
by pressing the INPUT "1" button.
4 Use the CURSOR
or
SELECT" item, then press ENTER to display the "S-VIDEO
MODE SELECT" menu.
NOTE: The SETTING MODE has three menus. The "S-VIDEO
MODE SELECT" menu is on the first menu (P01). To access
P02 or P03 from P01, press and hold down the CTL button then
press the button; to return to P01 from P02 or P03, press
and hold down the CTL button then press the
button to highlight the "9/OPTION"
button to highlight the "1/SETTING
button to select the "S-VIDEO MODE
button.
– A D J U S T –
1 / S I G N A L E N T R Y
2 / F O C U S
3 / A L I G N M E N T
4 / C O N V E R G E N C E
5 / W H I T E B A L
6 / R , G , B G A I N
7 / H O U R M E T E R
8 / P A S S C O D E
9 / O P T I O N
– O P T I O N –
1 / S E T T I N G M O D E
2 / M E N U M O D E
3 / S E Q U E N C E R
4 / P J A D D R E S S
5 / V E R S I O N
P01
CONNECT CONDITION
ASTIG OUTPUT
DEGAUSS
POINT CONVERGENCE
S-VIDEO MODE SELECT
VIDEO MODE SELECT
68
OPTION – SETTING MODE –
STANDALONE
CEILING
FRONT
ENABLE
S2
AUTO