Power Button; Power Indicator - NEC PG-6200 User Manual

Rear Control Panel
B C
POWER CONTROL
B POWER Button
Turns the projector on or off when the projector is in the
standby condition (Main Power switch must be on and the
Standby indicator lit).
C CONTROL Button
Used with other buttons, similar to a shift key on a
computer. This is referred to as the CTL button in this
manual and has the same function as the CTL button on
the remote.
D OPERATE Button
Press to display the OPERATE menu. You can select the
following adjustment functions from this menu.
1/ PICTURE 4/ INPUT SELECT
2/ POSITION 5/ SOURCE INFO
3/ SOUND 6/ STATIC
NOTE: "3/SOUND" is not included in stand alone operate
menu.
E ENTER Button
Executes menu selection and switches input.
F END Button
Exits the adjustment mode.
G DOWN Button
Used to decrease values or move the cursor downward.
When used with the CONTROL button, the DOWN
button works as the CURSOR
control unit.
D E F G
OPERATE ENTER END DOWN
button on the remote
H I J
NORMAL
UP
/ LOAD
H UP Button
Used to increase values or move the cursor upward. When
used with the CONTROL button, the UP button works as
the CURSOR button on the remote control unit.
I NORMAL/LOAD Button
Returns the adjustment data to the standard level (factory
preset level). While holding down the CONTROL button,
press the NORMAL button to display the "LOAD/
CANCEL" menu to select either LOAD (last stored level)
or CANCEL (data cancelled).
J Two Digit Display
Displays projector error codes. ("00" in normal operation)
K REMOTE Indicator
Flashes to acknowledge when the projector receives a
signal from the remote control.
L STANDBY Indicator
Lights up when the projector's main POWER switch is
on. Flashes when the projector might not be connected
with the Switcher correctly or when the Switcher is turned
off.
M POWER Indicator
Lights up when the projector is turned on.
N Remote Sensor
Receives the signal from the supplied remote control
when used in the wireless condition.
5
PART NAMES AND FUNCTIONS
K L M N
REMOTE STANDBY POWER