NEC PG-6200 User Manual page 6

1 POWER Buttons (ON/OFF)
Press the ON button to turn the projector on when the
projector is in the standby condition (STANDBY indica-
tor lit). Press the OFF button to return the projector to the
standby condition.
2 TEST Button
Press to display the "TEST PATTERN" menu from which
you can select a test pattern.
3 ADJUST Button
Press to display the "ADJUST" menu.
4 OPERATE Button
Press to display the "OPERATE" menu.
5 Backlight Switch
Turns the backlight on and off.
If another button operation is not made within 30 seconds
during the Backlight ON, the Backlight is normally turned
off to conserve the batteries.
6 PIC FUNC Button
Press to display the picture adjustment screen.
NOTE: Some function items will not be available
depending on the type of video signal.
7 SOUND FUNC Button
Press to display the VOLUME adjustment screen. You
can adjust the volume of the ISS-6010/ISS-6010G
Switcher.
8 PICTURE (PIC) MUTE Button
Press to mute the picture. Press again to display the
picture.
9 SOUND MUTE Button
Press to mute the sound. Press again to return the sound.
NOTE: This works only with the ISS-6010/ISS-6010G
Switcher.
0 DISPLAY Button
Press to turn on or off the on-screen display. Pressing with
CTL eliminates the on-screen display; pressing with CTL
again restores it.
NOTE: Even if the on-screen display may be turned off
with pressing CTL and DISPLAY, any adjustment will
still change the projector's memory settings. This mode
is available even when an input is switched to another or
the power is turned off using the POWER OFF button on
the remote control.
A FOCUS Button
Press to enter the FOCUS mode.
B STATIC Button
Press to enter the STATIC mode. You can adjust the static
convergence.
C POINT Button
(When the point convergence board installed)
Press to enter the POINT mode. You can adjust the point
convergence.
D TILT Button
Press to enter the TILT, SKEW mode. You can adjust the
tilt and the skew of the projected image.
E BOW Button
Press to enter the BOW mode. You can adjust the hori-
zontal and the vertical bow of the projected image.
F AMPLIT Button
Press to enter the AMPLITUDE mode. You can adjust the
horizontal width and the vertical height of the projected
image.
G LINEAR Button
Press to enter the LINEARITY mode. You can adjust the
horizontal and the vertical linearity of the projected
image. Pressing with CTL will bring you to the LINEAR-
ITY-BALANCE adjustment screen.
H KEYSTN Button
Press to enter the KEYSTONE mode. You can adjust the
horizontal and the vertical keystone of the projected
image. Pressing with CTL button will bring you to the
KEY-BALANCE alignment screen.
7
PART NAMES AND FUNCTIONS