NEC PG-6200 User Manual page 10

To change to the ceiling mount system (rear)
1) Reverse the scan.
H –––1-Red, 2-Blue
V –––1-Yellow, 2-Brown
A –––1-Blue, 2-Red
B –––1-Yellow, 2-Brown
2) Set the focus ring to the proper position.
For 60" screen size
R –––A-2, B-2
G –––A-1, B-2
B –––A-2, B-2
3) Adujust the angle of the CRT's.
For 60" screen size
Move the CRT to the 60 positon.
4) Adjust the decorative lens panel.
For 60" screen size
Adjust to match the 60 position
5) Degauss the projector. See "Degaussing" on page 64 in the set-up manual.
To change to the front desk top system (rear, 0 projection angle)
1) Reverse the scan.
H –––1-Blue, 2-Red
V –––1-Brown, 2-Yellow
A –––1-Red, 2-Blue
B –––1-Brown, 2-Yellow
2) Set the focus ring to the proper position.
For 60" screen size
R –––A-2, B-1
G –––A-1, B-1
B –––A-2, B-1
3) Adujust the angle of the CRT's.
For 60" screen size
Move the CRT to the 60 positon.
4) Adjust the decorative lens panel.
For 60" screen size
Adjust to match the 60 position
5) Degauss the projector. Select installation type from ASTIG OUTPUT.
See "ASTIG OUTPUT" on page 62 in the set-up manual.
PROJECTION CONFIGURATION CHANGE
For 200-300" screen size
R –––A-5, B-5
G –––A-1, B-5
B –––A-5, B-5
For 200-300" screen size
Move the CRT to the 200 or 300 position
For 200-300" screen size
Adjust to match the 200 or 300 position
For 200-300" screen size
R –––A-5, B-1
G –––A-1, B-1
B –––A-5, B-1
For 200-300" screen size
Move the CRT to the 200 or 300 position
For 200-300" screen size
Adjust to match the 200 or 300 position
9