Pre-Operation Inspection And Service - Schulte GLADIATOR RWP-1935 Operator's Manual

NOTE: When raising the wings to put the machine into transport position, the wings should be spread fully and
the Red Cylinder Lock-Up Spacers should be installed over the cylinder rods, When not in use, the Lock-Up
Spacers should be installed on the storage location on the Hitch Frame near the pivot of the Float Frame.

8.PRE-OPERATION INSPECTION AND SERVICE

Before each use, a pre-operation inspection and service of the implement and tractor must be performed. This
includes routine maintenance and scheduled lubrication, inspecting that all safety devices are equipped and
functional, and performing needed repairs. DO NOT operate the rock picker and tractor if the pre-operation
inspection reveals any condition affecting safe operation. Perform repairs and replacement of damaged and
missing parts as soon as noticed. By performing a thorough pre-operation inspection and service, valuable
down time and repair cost can be avoided.
Never work under the Implement, the framework, or any lifted component
unless the Implement is securely supported or blocked up to prevent
sudden or inadvertent falling which could cause serious injury or even
death.
Periodically inspect all moving parts for wear and replace when necessary
with authorized service parts. Look for loose fasteners, worn or broken
parts, and leaky or loose fittings. Make sure all pins have cotter pins and
washers. Serious injury may occur from not maintaining this machine in
good working order.
Always disconnect any PTO attachments from the Tractor before performing service on the
Implement. Never work on the Implement with the tractor PTO attachment connected and
running. Rotating parts, drums, teeth, chains, or drives could turn without warning and cause
immediate entanglement, injury or death.
Gladiator RWP-1935 01/23
© 2023 Alamo Group Inc.
OPERATION
(SG-43) str
(SG-21 )str
Operation Section 4-16
(S3PT-24)str