Table of Contents
Advertisement
11.4 Shutting Down the Implement
To shut down the implement, first bring the tractor
to a complete stop. Then slow down the rock
picker by reducing the engine speed before
disengaging the hydraulics and the PTO. Wait for
all rotating motion to stop before proceeding to
drive or shut down the tractor.
Park the tractor on a level surface, place the
transmission in park or neutral and apply the
parking brake, lower the attached implement to
the ground, shut down the engine, remove the
key, and wait for all motion to come to a complete
stop before exiting the tractor.
12.DISCONNECTING THE ROCK PICKER FROM THE TRACTOR
Always shut the Tractor completely down, place the transmission in park, and set the parking
brake before you or anyone else attempts to connect or disconnect the Implement and
Tractor hitches.
Never stand or allow another person to stand between a running Tractor and the Unit when
disconnecting the Implement from the Tractor. Always shut the Tractor off completely and set
the parking brake before attempting to disconnect the Implement pins from the Tractor hitch.
Before disconnecting the implement, the PTO and master switch must be disengaged and all rotation at a
complete stop. Move the implement to a level storage location and lower the implement to the ground. If the
implement is not resting securely on the ground, block the implement up securely before attempting to
disconnect it from the tractor.
Use extreme care to keep feet and hands out from under the implement and clear of any pinch points when
disconnecting the implement from the tractor.
1. When disconnecting the implement, the
tractor should be completely shut down and
secured
in
position.
pressure by moving the control levers back
and forth several times.
2. Lower the parking jack and raise the unit until
the tongue clevis is no longer resting on the
tractor drawbar and is supported solely by the
jack. Make sure the jack foot is securely
resting at ground level or securely supported
by a block before raising the unit.
3. Once the unit tongue is being supported
entirely by the jack, remove the hitch pin, and
lynch pin.
Gladiator RWP-1935 01/23
© 2023 Alamo Group Inc.
OPERATION
(S3PT-15) str
Relieve
hydraulic
Operation Section 4-34
Advertisement
Table of Contents
