Drum Sprocket - Schulte GLADIATOR RWP-1935 Operator's Manual

ASSEMBLY
Install Hub/Axle Assemblies as shown.
Install the tire/rim assemblies onto the hubs using
eight wheel nuts per wheel. Torque nuts to 180 ft/
lbs (250 Nm). Inflate tires to 36 psi.
.

DRUM SPROCKET

After locking the collars on drum end bearings,
slide big sprocket on shaft until it is against lock
collar.
Insert hub and keys into sprocket.
Tighten hub by alternately tightening the three
bolts in hub. Tighten the bolts to 29 ft.-lbs (39
Nm). Over tightening will strip out bolts.
Slide the appropriate amount of machine
bushings until they are flush with end of shaft,
then cap off and tighten end bolt.
Gladiator RWP-1935 01/23 Assembly Section 3-3
© 2023 Alamo Group Inc.