Table of Contents
Advertisement
3. TRACTOR REQUIREMENTS
The tractor used to operate the implement must have the power capacity to lift, pull, operate the reel hydraulic
motor and operate the Power Take Off (PTO) at the Rock Picker's rated speed while traveling at a ground
speed between 2 and 5 MPH. Operating the implement with a tractor that does not meet the following
requirements may cause tractor or implement damage and be a potential danger to the operator and
passersby.
Tractor Requirements and Capabilities
• ASABE approved Roll-Over Operator Protective Structure and Seatbelt.
• Tractor Safety Devices ........................... Slow Moving Vehicle (SMV) emblem, lighting, PTO master shield
• Tractor Horsepower - Recommended..... Minimum 125 hp (93kw)
• Drawbar .................................................. Set length according to operating speed and driveline type, rated to
• Front End Weights .................................. As needed to maintain 20% weight on front axle
• Hydraulics .............................................. 9.6 gpm @ 1750 PSI, 2 remote outlets
• Power Take Off
3.1 ROPS and Seat Belt
The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat
belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be
crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened.
Tractor models not equipped with a ROPS and seat belt should have these life saving features installed by an
authorized dealer. OPS-U- 0003str
Operate this Equipment only with a Tractor equipped with an approved roll-over-
protective system (ROPS). Always wear seat belts. Death or serious injury could
result from falling off the tractor, particularly during a turnover when the operator
could be pinned under the ROPS.
3.2 Tractor Safety Devices
If transporting or operating the tractor and implement near a public roadway, the tractor must be equipped with
proper warning lighting and a Slow Moving Vehicle (SMV) emblem which are clearly visible from the rear of the
unit. Lights and a SMV emblem must be equipped directly on implements if the visibility of the tractor warning
signals are obscured.
Maintain all manufacturer equipped safety shields and guards. Always replace shields and guards that were
removed for access to connect, service, or repair the tractor or implement. Never operate the tractor PTO with
the PTO master shield missing or in the raised position. OPS-U- 0004str
3.3 Tractor Horsepower
The horsepower required to operate the implement depends on several operating factors including terrain
condition, operator experience, condition of the implement and tractor, and other factors. The recommended
tractor HP for the GLADIATOR RWP-1935 is 125 HP (93 kW). Operating the implement with to large of a
tractor will greatly increase the risk of damaging the implement
Gladiator RWP-1935 01/23
© 2023 Alamo Group Inc.
OPERATION
carry weight of the mower, safety chain attachment point
Operating speed and shaft size should match the PTO pump option
chosen
(SG-7) str
Operation Section 4-5
Advertisement
Table of Contents
