Table of Contents
Advertisement
6.5 Connecting the Electronic Controls to the Tractor
All hydraulic cylinder circuits are powered by one
tractor remote, and controlled by a control valve.
The valve is controlled by a switch box that will be
placed in the tractor cab.
1. Install the switchbox 276-348 into an easily
accessible place in the tractor cab.
2. Locate the two Ring Terminals and connect
them to the tractor power source.
3. Feed the cable out the back of the tractor and
connect it to the implement side harness 276-
349.
•
Allow some slack in the section of wiring
between the implement and tractor, other-
wise the cable may tighten while traveling
over rough terrain or turning and cause
damage to the cables, connectors, valve,
switchbox, or tractor.
7.SETTING THE WINDROWERS
Properly setting the wing height is essential for efficient and safe operation. A properly set implement will feed
the rock picker more evenly, require minimal tractor work, and follow the contour of uneven terrain.
Note: Avoid very low windrowing heights. Striking the ground with the teeth gives the most damaging shock
loads and will cause damage to the windrower and drive. Windrower teeth contacting the ground may cause
objects to be thrown out from under the windrower deck.
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause death or
serious injury.
7.1 Adjusting Drum Level
Drum level will need to be adjusted and fine tuned to match terrain and desired field finish. To initially set the
drums, follow these instructions.
Ensure that no one is near the machine while hydraulics are being activated.
1. First find a level area and unfold the machine.
2. Lower the frame until the Grate Teeth just touch the ground.
Gladiator RWP-1935 01/23
© 2023 Alamo Group Inc.
OPERATION
(SG-14)str
Operation Section 4-13
Advertisement
Table of Contents
