Drive Chain; Storage - Schulte GLADIATOR RWP-1935 Operator's Manual

Drive Chain

• Apply light grease or oil to the drive chain after every 8 hours of operation. Operating conditions may
require that the chain be lubricated more frequently. Do not allow the chain to dry out.
Fully retract the hydraulic cylinders and install the transport pins. Retracting the cylinder rods will prevent
rusting, ensure that the cylinders are full of oil, and relieve pressure in the hydraulic circuit. Smear grease over
any part of the hydraulic cylinder rod that remains exposed.
Before disconnecting hydraulic lines place the grate in transport position and install the
transport pins

STORAGE

If possible, store your rock picker under cover,
Install hitch jack on the lug at the front of the hitch.
It is recommended that drive chains be removed from the machine, cleaned and stored in oil over the winter
months, It this is not possible, apply oil to all chains and sprockets.
Where possible, fully retract the hydraulic cylinders and install transport pins. Retracting cylinder rods will
prevent rusting, ensure that the cylinders are full of oil, and relieve pressure in the hydraulic circuit. Smear
grease over any part of the hydraulic cylinder rod that remains exposed.
Check that all transport locks are in good condition and, if removed, reinstall all locks before moving the
machine.
Gladiator RWP-1935 01/23
© 2023 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-15